ל VERAPLUS.
ניסיתי באמצעות ADD DEVICE ובחיפוש לפי ROLLER נמצא ROLLER של FIBARO אבל
V2, זה משנה?
אח"כ ניסתי באמצעות ADD GENERIC DEVICE גם ללא תוצאה.
ניסיתי FACTORY RESET כמתואר, אבל אני לא מצליח להתקדם מכאן.....
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to reset the device into factory default. You can do this by performing an Exclusion operation as described below in the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Press and hold the B-button to enter the menu.
Wait for the LED indicator to glow yellow.
Quickly release and click the B-button again.
After few seconds the device will be restarted, which is signalled with the red LED indicator color.
