חפשתי טיפה...
להחליף מקרן בטלוויזיה אם שלך מחוברת ,
On some receivers, there's an TV HDMI audio out sel-ection in the receiver's setup menu. Make sure that's off. If that's set to "on", the audio will be downcoverted to 2 channel PCM internally and sent to your projector. That's your receiver doing that--not the ATI driver. That receiver setup setting (when enabled) is intended for using the volume control with a t.v. and not for use with the receiver's volume control....
מכיוון שHDMI הוא דו כיווני אז ההנחתה מגיעה כפקודה מהמגבר, ואז הכרטיס יורד ל2.I just found out this setting in the online manual of my receiver:
HDMI AUDIO:
This setting determines whether to play back audio input to the HDMI jacks through the unit or output it through the unit to a TV or projector. ENABLE: The audio input to the HDMI jacks can be played back by this unit. In such case, audio signals are not output to the TV or projector. THROUGH: The audio input to the HDMI jacks is not output from the speaker terminals of the unit. Audio data is output directly to the TV or projector. This setting is used to listen to audio on a multi channel TV, etc.
Could this maybe be the setting you re talking about? If it is, then lest hope it is on THROUGH now (can t see until tonight, I m at the office right now) so I can switch this to ENABLE....
שיניתי טיפה הגדרות מאז ולא מצליח יותר....
